Arduino Sensor Shield V5 0 Manual -

Locate the right next to the blue terminal block.

A 4-pin header mapped to Tx, Rx, 5V, and GND for HC-05 or HC-06 modules. arduino sensor shield v5 0 manual

Remember that on boards like the Arduino Uno, the I2C lines (SDA/SCL) share the exact same hardware channels as pins A4 and A5 . If you use an I2C display, avoid using analog pins A4 and A5 for other sensors. Locate the right next to the blue terminal block

No drivers are required for the shield itself because it is just a wiring harness. Here is how to mount it correctly. If you use an I2C display, avoid using

This is a classic power starvation issue. Remove the SEL jumper and use an external 5V power supply via the blue screw terminal block.

The shield receives power from the Arduino’s USB or DC jack. Best for small numbers of low-current sensors. External Power: Connect a